Да ли су вам стандарди потребни у вашем послу?
Да
Не
Понекад
Не знам
Укупан број гласова: 7163

Пријавите се!
 


naSRPS EN 1254-20:2019

Фаза: 40.20 - Почетак јавне расправе о нацрту српског стандарда
Почетак: 2019-07-03
Крај: 2019-09-03

Веза са међународним стандардима
Ovaj standard je identičan sa: prEN 1254-20 CEN/TC 133

Наслов на српском језику

Bakar i legure bakra — Fitinzi za vodovodne instalacije — Deo 20: Definicije, dimenzije navoja, metode ispitivanja, referentni podaci i prateće informacije

Наслов на енглеском језику

Copper and copper alloys - Plumbing fittings - Part 20: Definitions, thread dimensions, test methods, reference data and supporting information

Апстракт на српском језику

Ovaj dokument sadrži definicije, dimenzije navoja, referentne podatke (minimalno telo navoja), prateće informacije (uputstva za spajanje) i opisuje metode ispitivanja koje su navedene u drugim delovima EN 1254 serije.

Апстракт на енглеском језику

This document contains definitions, thread dimension, reference data (minimum bore), supporting information (assembling instructions) and describes the test methods referenced by other parts of the EN 1254 series. Thread dimensions comprise: wall thickness at threaded portions of fittings, dimensions of tail pipe ends for swivel fittings, dimensions of gas union connectors, thread dimensions and thread profile. Test methods comprise: leak tightness under internal hydrostatic pressure, leak tightness under internal pneumatic pressure, resistance of joints to static flexural strength, resistance to pull out of joints, leak tightness of joints under vacuum, the resistance of joints to temperature cycling, resistance of joints with metallic tube to vibration, integrity of fabricated fitting bodies or having an ''as cast'' microstructure, resistance to stress corrosion, detection of a carbon film on the surface of copper fittings, determination of mean depth of dezincification, resistance of joints to pressure cycling, disconnection and re-use, determining if the diameter and/or the length of engagement of a capillary end is/are within the specified tolerance, determining the minimum length of engagement of an integral solder or brazing ring socket having a formed groove.

Комисија за стандарде


ICS



Директиве

Нема информација.