Да ли су вам стандарди потребни у вашем послу?
Да
Не
Понекад
Не знам
Укупан број гласова: 7216

Пријавите се!
 


naSRPS EN 1254-8:2018

Фаза: 40.60 - Завршетак јавне расправе
Почетак: 2019-09-03
Крај: 2019-11-03

Веза са међународним стандардима
Ovaj standard je identičan sa: prEN 1254-8 CEN/TC 133

Наслов на српском језику

Bakar i legure bakra — Fitinzi za vodovodne instalacije — Deo 8: Fitinzi koji se utiskuju pri upotrebi kod plastičnih i višeslojnih cevi

Наслов на енглеском језику

Copper and copper alloys - Plumbing fittings - Part 8: Press fittings for use with plastics and multilayer pipes

Апстракт на српском језику

Ovim dokumentom se utvrđuju karakteristike proizvoda, metode procene, kriterijum usaglašenosti i sistem označavanja fitinga sa krajevima koji se utiskuju radijalno i aksijalno za upotrebu kod plastičnih i višeslojnih cevovoda. Krajevi fitinga imaju opseg veličina od 10 mm do 160 mm. Fitinzi su projektovani za radni vek do pedeset godina.

Апстракт на енглеском језику

This document specifies product characteristics, assessment methods, compliance criteria and a designation system for fittings with radial and axial press ends for use with plastics and multilayer pipes. The fitting ends have a size range from 10 mm to 160 mm. The fittings are designed for a service lifetime up to fifty. This document applies to copper alloy fittings. A non-exhaustive list of these copper alloys is given in CEN/TS 13388. Adaptor fittings for use with plastic and multilayer pipes may combine press ends with fitting ends defined in the other parts of EN 1254. Press fittings for use with plastic and multilayer pipes may also have flanged end connections according to EN 1092-3. Press fittings for use with plastic and multilayer pipes may also have a plated or other decorative surface coating. Fittings can be produced by machining, metal forming, casting, or fabrication. Products covered by this standard are intended to be used in: a) liquid applications: - hot, cold or combined hot and cold water systems according to EN 806; - closed heating systems according to EN 12828 and cooling systems; - drainage systems; - sprinkler systems according to EN 12845; b) gas applications: - natural gas and liquefied petroleum gas systems with a maximum operating pressure less than or equal to 5 bar according to EN 1775; - compressed air systems.

Комисија за стандарде


ICS



Директиве

Нема информација.