Да ли су вам стандарди потребни у вашем послу?
Да
Не
Понекад
Не знам
Укупан број гласова: 7216

Пријавите се!
 


naSRPS EN 1254-3:2018

Фаза: 40.60 - Завршетак јавне расправе
Почетак: 2019-09-03
Крај: 2019-11-03

Веза са међународним стандардима
Ovaj standard je identičan sa: prEN 1254-3 CEN/TC 133

Наслов на српском језику

Bakar i legure bakra – Fitinzi za vodovodne instalacije- Deo 3: Stezni fitinzi za upotrebu za plastične i višeslojne cevovode

Наслов на енглеском језику

Copper and copper alloys - Plumbing fittings - Part 3: Compression fittings for use with plastics and multilayer pipes

Апстракт на српском језику

Ovim dokumentom se utvrđuju karakteristike proizvoda, metode procene, kriterijum usaglašenosti rezultata ispitivanja i sistem za označavanje steznih fitinga za upotrebu za plastične i višeslojne cevovode, koje su definisane u važećem standardu za cevovode. Za spajanje plastičnih cevi, krajevi fitinga imaju opseg veličina od 10 mm do 160 mm. Fitinzi su projektovani za radni vek do pedeset godina.

Апстракт на енглеском језику

This document specifies product characteristics, assessment methods, compliance criteria of test results and a designation system for fittings with compression ends for use with plastic and multilayer pipes which are defined in the applicable pipe standard. For the purposes of joining plastics pipes, the fitting ends have a size range from 10 mm to 160 mm. The fittings are designed for a service lifetime up to fifty years. The compression fittings are used up to the operating temperatures and maximum operating pressures as indicated in Annex A. This European Standard applies to copper alloy fittings. A non-exhaustive list of these copper alloys is given in CEN/TS 13388. Adaptor fittings for use with plastic and multilayer pipes may combine compression ends with fitting ends defined in the other parts of EN 1254. Compression fittings for use with plastic and multilayer pipes may also have flanged end connections according to EN 1092-3. Compression fittings for use with plastic and multilayer pipes may also have a plated or other decorative surface coating. Fittings can be produced by machining, metal forming, casting, or fabrication. Products covered by this standard are intended to be used in: a) liquid applications: - Hot, cold or combined hot and cold water systems according to EN 806; - closed heating systems according to EN 12828 and cooling systems; - drainage systems; - sprinkler systems according to EN 12845. b) gas applications (not valid for multilayer pipes): - natural gas and liquefied petroleum gas systems with a maximum operating pressure less than or equal to 5 bar according to EN 1775; - compressed air systems.

Комисија за стандарде


ICS



Директиве

Нема информација.