Да ли су вам стандарди потребни у вашем послу?
Да
Не
Понекад
Не знам
Укупан број гласова: 7058

Пријавите се!
 


dnaSRPS EN ISO 19065-2:2017

Фаза: 50.60 - Завршетак поступка одобравања дефинитивног текста нацрта српског стандарда
Почетак: 2019-02-07
Крај: 2019-04-07

Веза са међународним стандардима
Ovaj standard je identičan sa: EN ISO 19065-2:2019 CEN/TC 249
Ovaj standard je identičan sa: ISO 19065-2:2019 ISO/TC 61/SC 9

Наслов на српском језику

Plastične mase — Akrilonitril/stiren/akrilatni (ASA), akrilonitril/(etilen-propilen-dien)/ stirenski (AEPDS) i akrilonitril/hlorovani polietilen/stirenski (ACS) materijali za presovanje i ekstrudiranje — Deo 2: Priprema uzoraka i određivanje svojstava

Наслов на енглеском језику

Plastics - Acrylonitrile-styrene-acrylate (ASA), acrylonitrile-(ethylene-propylene-diene)-styrene (AEPDS) and acrylonitrile-(chlorinated polyethylene)-styrene (ACS) moulding and extrusion materials - Part 2: Preparation of test specimens and determination of properties (ISO 19065-2:2019)

Апстракт на српском језику

Нема информација.

Апстракт на енглеском језику

This document specifies the methods of preparation of test specimens and the test methods to be used in determining the properties of acrylonitrile-styrene-acrylate (ASA), acrylonitrile-(ethylene-propylenediene)-styrene (AEPDS) and acrylonitrile-(chlorinated polyethylene)-styrene (ACS) moulding and extrusion materials. Requirements for handling the test material and for conditioning both the test material before moulding and the specimens before testing are given. Procedures and conditions for the preparation of test specimens and procedures for measuring properties of the materials from which these specimens are made are given. Properties and test methods which are suitable and necessary to characterize ASA, AEPDS and ACS moulding and extrusion materials are listed. The properties have been selected from the general test methods in ISO 10350-1. Other test methods in wide use for, or of particular significance to, these moulding and extrusion materials are also included in this document, as are the designatory properties specified in ISO 19065-1. In order to obtain reproducible and comparable test results, it is intended to use the methods of specimen preparation and conditioning, the specimen dimensions and the test procedures specified in this document. Values determined will not necessarily be identical to those obtained using specimens of different dimensions or prepared using different procedures.

Комисија за стандарде


ICS



Директиве

Нема информација.