Да ли су вам стандарди потребни у вашем послу?
Да
Не
Понекад
Не знам
Укупан број гласова: 7306

Пријавите се!
 


naSRPS EN 10025-2:2017

Фаза: 40.60 - Завршетак јавне расправе
Почетак: 2018-09-06
Крај: 2018-08-14

Веза са међународним стандардима
Ovaj standard je identičan sa: EN 10025-2:2019 CEN/TC 459/SC 3

Наслов на српском језику

Toplovaljani proizvodi od konstrukcionih čelika - Deo 2: Tehnički zahtevi za isporuku nelegiranih konstrukcionih čelika

Наслов на енглеском језику

Hot rolled products of structural steels - Part 2: Technical delivery conditions for non-alloy structural steels

Апстракт на српском језику

Delom 2 ovog dokumenta, uz Deo 1, utvrđuju se tehnički zahtevi za isporuku pljosnatih i dugačkih proizvoda i poluproizvoda koji su namenjeni za dalju obradu u pljosnate i dugačke proizvode kvaliteta toplovaljanih nelegiranih čelika u vrste i kvalitete navedene u tabelama od 2 do 6 (hemijski sastav) i u tabelama od 7 do 9 (mehaničke osobine) u stanju isporuke, onako kako je to dato u 6.3. Ovaj deo se ne odnosi na šuplje profile i cevi od konstrukcionih čelika (vedeti EN 10210-1 i EN 10219-1).

Апстракт на енглеском језику

This document specifies the technical delivery conditions for flat and long products as well as semi-finished products which are meant for further processing to flat and long products of hot rolled non-alloy quality steels in the grades and qualities given in Tables 1 to 5 (chemical composition) and Tables 6 to 8 (mechanical properties) in the usual delivery conditions as given in 6.3. Three engineering steels are also specified in this document (see Tables 2 and 4) (chemical composition) and Table 7 (mechanical properties). This document does not apply to structural hollow sections (see EN 10210 1 and EN 10219 1) and tubes. The technical delivery conditions apply to: - thicknesses ≥ 3 mm and ≤ 150 mm for long products of steel grade S460JR, J0, J2, K2 and S500J0; - thicknesses ≤ 400 mm for flat products of qualities JR, J0, J2 and K2; - thicknesses ≤ 250 mm for flat and long products of all other grades and qualities. The steels specified in this document are not intended to be heat treated except products delivered in the delivery condition +N. Stress relieving is accepted. Products delivered in +N condition can be hot formed and/or normalized after delivery (see Clause 3). This document foresees that semi-finished products which are to be converted to rolled finished products conforming to this document are the subject of special agreements at the time of the order. The chemical compositions are also agreed to at the time of the order; the values are within the limits of Tables 1 and 2. For certain grades and product forms suitability for particular applications are specified at the time of the order (see 7.4.2, 7.4.3 and Table 9).

Комисија за стандарде


ICS



Директиве

Нема информација.