Да ли су вам стандарди потребни у вашем послу?
Да
Не
Понекад
Не знам
Укупан број гласова: 7320

Пријавите се!
 


nkSRPS EN 10217-2:2017

Фаза: 30.60 - Завршетак рада/изјашњавања о нацрту српског стандарда
Почетак: 2019-05-06
Крај: 2019-07-06

Веза са међународним стандардима
Ovaj standard je identičan sa: EN 10217-2:2019 CEN/TC 459/SC 10

Наслов на српском језику

Šavne čelične cevi za opremu pod pritiskom - Tehnički zahtevi za isporuku - Deo 2: Cevi od nelegiranog i legiranog čelika proizvedene postupkom elektrozavarivanja sa osobinama utvrđenim za povišenu temperaturu

Наслов на енглеском језику

Welded steel tubes for pressure purposes - Technical delivery conditions - Part 2: Electric welded non-alloy and alloy steel tubes with specified elevated temperature properties

Апстракт на српском језику

Ovim standardom specificiraju se tehnički zahtevi za isporuku za dve kategorije ispitivanja šavnih čeličnih cevi kružnog poprečnog preseka sa osobinama utvrđenim za povišene temperature od nelegiranih čelika.

Апстракт на енглеском језику

This document specifies the technical delivery conditions for two test categories of electric welded tubes of circular cross section, with specified elevated temperature properties, made from non-alloy quality steel or alloy special steel. NOTE 1 These tube grades are intended to support the essential requirements of EU Directive 2014/68/EU in respect of pressure equipment with specified elevated temperature properties, covered under all relevant Categories as set out in Article 13 of that Directive. NOTE 2 Once this standard is published in the Official Journal of the European Union (OJEU), presumption of conformity to the Essential Safety Requirements (ESR) of Directive 2014/68/EU is limited to the technical data for the materials in this standard and does not presume adequacy of the material for a specific item of pressure equipment. Consequently, the assessment of the technical data stated in this material standard against the design requirements of a specific item of equipment to verify that the ESRs of the Pressure Equipment Directive are satisfied, needs to be done by the designer or manufacturer of the pressure equipment, taking also into account any subsequent processing procedures which may affect properties of the base materials.

Комисија за стандарде


ICS



Директиве