Да ли су вам стандарди потребни у вашем послу?
Не знам
Укупан број гласова: 7482

Пријавите се!

SRPS EN 15502-2-1:2013

Статус: Повучен
Језик: Engleski
Бр. страна: 85
Датум: 26.04.2013.
Датум повлачења: 31.01.2017 .
Службени гласник: 40/13
Број решења:
Издање: 1 ED
Веза са међународним стандардима
Ovaj standard je identičan sa:
EN 15502-2-1:2012   CEN/TC 109
Цена: 4920 RSD

За читање онлајн


Наслов на српском језику

Kotlovi za centralno grejanje na gasovita goriva — Deo 2-1: Poseban standard za aparate tipa C i aparate tipa B2, B3 i B5, nazivnog toplotnog opterećenja koje ne prelazi 1 000 kW

Наслов на енглеском језику

Gas-fired central heating boilers - Part 2-1: Specific standard for type C appliances and type B2, B3 and B5 appliances of a nominal heat input not exceeding 1 000 kW

Апстракт на српском језику

Ovim standardom utvrđuju se, zahtevi i metode ispitivanja koja se odnose, posebno na konstrukciju, bezbednost, prikladnosti za namenu, i racionalno korišćenje energije, kao i klasifikaciju i obeležavanja kotlova za centralno grejanje na gasovita goriva koji su opremljeni sa atmosferskim gorionicima, atmosferskim gorionicima sa pomoćnim ventilatorima ili gorionicima sa potunim predmešanjem

Апстракт на енглеском језику

This European Standard specifies, the requirements and test methods concerning, in particular, the construction, safety, fitness for purpose, and rational use of energy, as well as the classification and marking of gas-fired central heating boilers that are fitted with atmospheric burners, fan assisted atmospheric burners or fully premixed burners, and are hereafter referred to as "boilers". Where the word boiler is used, it needs to be read as the boiler including its connecting ducts, ducts and terminals, if any. This European Standard covers gas-fired central heating boilers from the types C1 up to C9 and the types B2, B3 and B5, according to the classification in CEN/TR 1749: a) that have a nominal heat input (on the basis of net calorific value) not exceeding 1 000 kW; b) that use one or more combustible gases of the three gas families at the pressures stated in EN 437; c) where the temperature of the heat transfer fluid does not exceed 105 °C during normal operation; d) where the maximum operating pressure in the water circuit does not exceed 6 bar; e) which may or may not give rise to condensation under certain circumstances; f) which are declared in the installation instructions to be either a "condensing" boiler or a "low temperature boiler" or a "standard boiler"; if no declaration is given the boiler is to be considered a "standard boiler"; g) which are intended to be installed either indoors or outdoors in a partially protected place; h) which may include the facility to produce hot water, either by the instantaneous or storage principle, the whole being marketed as a single unit; i) which are designed for either sealed water systems or for open water systems; j) which are either modular boilers, or non- modular boilers. This European Standard will be used in conjunction with the General Requirements Standard EN 15502-1. This European Standard provides requirements for boilers with known constructions. For boilers with any alternative constructions, which might not fully be covered by this standard, the risk associated with this alternative construction needs to be assessed. An example of an assessment methodology, based upon risk assessment and which covers the essential requirements of the Gas Appliance Directive, is given in Clause 11. This European Standard does not cover all the requirements for: k) Appliances that are intended to be connected to gas grids where the quality of the distributed gas is likely to vary to a large extent over the lifetime of the appliance (see Annex DD); l) Appliances using flue dampers; m) Appliances of the types B21, B31, B51, C21, C41, C51, C61, C71 and C81; n) C7 appliances that have a nominal heat input (on the basis of net calorific value) exceeding 70 kW; o) Appliances incorporating flexible plastic flue liners; p) Appliances designed to become connected to a combined flue duct system that is designed to operate under overpressure (for example Ca)); q) Appliances incorporating a combined combustion products circuit that is designed to operate under overpressure (for example Cb)); r) Appliances intended to be connected to a (common) flue having mechanical extraction.

Комисија за стандарде



Нема информација.

Национални пропис

Национална активност

SRPS EN 15502-2-1:2013 zamenjuje SRPS EN 483:2010 - 26.04.2013


kotlovska postrojenja, kotlovi za centralno grejanje, gas, klasifikacija, konstrukcija, električna bezbednost, upravljanje, obeležavanje, uptstva