Logo Институт за стандардизацију Србије 11030 Београд, Стевана Бракуса 2, п. п. 2105 Тел. 011 7541-262 лок. 135, 011 6547-496 Факс: 011 7541257 Date: 2019-12-12
Time: 19:05

SRPS CLC/TR 50422:2012

Статус: Повучен
Језик: Engleski
Бр. страна: 24
Датум: 30.03.2012.
Датум повлачења: 30.11.2015 .
Службени гласник: 30/12
Број решења:
Издање: 1 ED
Веза са међународним стандардима
Ovaj standard je identičan sa:
CLC/TR 50422:2003   CLC/TC 8X
Цена: 2737 RSD

За читање онлајн


Наслов на српском језику

Uputstvo za primenu evropskog standarda EN 50160

Наслов на енглеском језику

Guide for the application of the European Standard EN 50160

Апстракт на српском језику

Cilj ovog uputstva je da pruži neke osnovne informacije i objašnjenja standarda SRPS EN 50160: Karakteristike napona isporučene električne energije iz javnih električnih mreža u pogledu istorije njegovog razvoja kao i u pogledu njegove ispravne primene.

Апстракт на енглеском језику

It is important to note that the scope of the standard is confined to the electricity supplied at the supply terminals, and does not deal with the supply system or the customer´s installation or equipment. The diagram below in Figure 1 illustrates the point which is defined in EN 50160 as “the supply terminals” and also the relationship between the impulse withstand requirements of the supply terminals, the customer’s installation and the customer’s electrical equipment. The appropriate categories of impulse voltage withstand for each zone are also highlighted. It should be stressed that the supply terminals, referred to in both the standard and this application guide, and the origin of the installation, referred to in both IEC 60664-1, Insulation coordination for equipment within low-voltage systems [5], and IEC 60364-4-44, Electrical Installations of buildings – Part 4 Protection for Safety Chapter 44 Protection against overvoltages (HD 384-4-443) [6], are one and the same point. As the standard is intended to deal only with the characteristics of the voltage at specified points on the public distribution networks, it does not deal directly with the characteristics of networks themselves, such as short circuit power. Clearly, however, the network characteristics will have an effect upon the magnitude of several of the phenomena described by the standard. The standard is applicable only under normal operating conditions of the supply system. This includes also the correct operation of protection devices in the case of a fault in the network (blowing of a fuse, operation of a circuit-breaker etc.); the operation of loads agreed between customer and distribution network operator (DNO – see clause 2.3 below) and changes in network configuration. When energy is supplied to the public networks from small private generators, it is important to keep the level of disturbances within acceptable limits. In this context private generation is in the same position as any customer’s installation and therefore has to comply with the related emission standards and agreed limits for the voltage supplied. As such the voltage supplied from the generator must comply with the requirements of EN 50160.

Комисија за стандарде

N013 - Општи аспекти за снабдевање електричном енегријом, мерење електричне енергије и управљање оптерећењем


29.020 - Elektrotehnika uopšte


Нема информација.

Национални пропис

Нема информација.

Национална активност

SRPS CLC/TR 50422:2014 zamenjuje SRPS CLC/TR 50422:2012 - 30.11.2015


distribucija, javna distribucija, napon

Овај сајт је реализован у оквиру пројекта CARDS 2006 Copyright © 2010 Institute for Standardization of Serbia