Do you use standards in your work?
Yes
No
Don't know
Total votes: 206
 


prSRPS EN 975-1:2019

Phase: 10.99 - Нови пројекат се прихвата
Start: 2019-01-01
End: 2019-03-01

Related international standards
This standard is identical to: EN 975-1:2009/AC:2010 CEN/TC 175
This standard is identical to: EN 975-1:2009 CEN/TC 175

Serbian title

Rezana građa — Klasiranje lišćara po izgledu — Deo 1: Hrast i bukva

English title

Sawn timber - Appearance grading of hardwoods - Part 1: Oak and beech

Serbian scope

No information added.

English scope

This European Standard specifies the rules determining the quality of appearance graded sawn timber. It describes various grades of temperate hardwood rough sawn timber and regularized timber for which it lays down denominations and definitions. It also gives rules for composition and acceptance of batches. This standard gives minimum requirements for each grade classification. Sawn timber not included within limits given in this standard may be defined, if necessary, by contract specifications established on the basis of this standard. This standard applies to grading of green and dried timber. Characteristics apply at the time of grading. This standard does not apply to the strength grading of structural timber or to sawn timber for pallets. This standard is applicable to the following products: a) Oak sawn timber, in the following categories: 1) Un-edged boards: individual selected pieces and boules; 2) Square edged timber and strips (not exceeding 41 mm thickness); 3) Baulks (sum of thickness + width greater than or equal to 200 mm and thickness greater than or equal to 80 mm). b) Beech sawn timber, in the following categories: 1) Un-edged boards: individual selected pieces and boules; 2) Square edged timber and strips; 3) Prepared timber (dried timber).

Technical committees


ICS



Directive

No information added.