COVID-19 – Important information about ISS business in the state of emergency
Do you use standards in your work?
Yes
No
Don't know
Total votes: 207
 


naSRPS EN 10111:2019

Phase: 40.20 - Почетак јавне расправе о нацрту српског стандарда
Start: 2020-01-24
End: 2020-03-24

Related international standards
This standard is identical to: EN 10111:2008 CEN/TC 459/SC 9

Serbian title

Kontinuirano toplovaljani lim i traka od niskougljeničnog čelika za hladno oblikovanje — Tehnički zahtevi za isporuku

English title

Continuously hot rolled low carbon steel sheet and strip for cold forming - Technical delivery conditions

Serbian scope

Ovim standardom se utvrđuju vrste toplovaljanih limova i traka (u koturu) od niskougljeničnog čelika namenjenih za hladno oblikovanje. U zavisnosti od njene stvarne širine, traka se klasifikuje kao: -toplovaljana široka traka čija je širina jednaka ili veća od 600 mm; -toplovaljana traka dobijena rasecanjem široke trake čija je širina manja od 600 mm. Za svaku vrstu trake utvrđeni su hemijski sastav i mehaničke osobine. Ovaj evropski standard se primenjuje na proizvode najmanje debljine 1,0 mm i najviše 11 mm. Ovaj evropski standard se ne primenjuje na proizvode koji su obuhvaćeni drugim standardima, kao što su: -toplovaljani proizvodi od nelegiranih konstrukcionih čelika za opštu upotrebu (videti EN 10025 sve delove); -čelični lim za opremu pod pritiskom (videti EN 10028 sve delove); -čelični lim za zavarene čelične boce za gas (videti EN 10120); -kaljeni i otpušteni čelici (videti EN 10083-1 i EN 10083-2).

English scope

This European Standard specifies the grades of continuously hot rolled low carbon steel sheet and strip (in coils) for cold forming. Depending on its actual width, strip is classified as: - hot rolled wide strip if its width is greater than or equal to 600 mm; - hot rolled slit wide strip if its width is less than 600 mm. For each grade, it specifies the chemical composition and the mechanical properties. This European Standard is applicable to products of thickness not less than 1,0 mm and not exceeding 11 mm. This European Standard is not applicable to products covered by other standards, such as: - hot rolled products of non-alloy structural steels for general use (see EN 10025 all parts); - steel sheet for pressure purposes (see EN 10028 all parts); - steel sheet for welded gas cylinders (see EN 10120); - quenched and tempered steels (see EN 10083-1 and EN 10083-2).

Technical committees


ICS



Directive

No information added.