Do you use standards in your work?
Yes
No
Don't know
Total votes: 186
 


dnaSRPS EN 10028-6:2017

Phase: 50.60 - Завршетак поступка одобравања дефинитивног текста нацрта српског стандарда
Start: 2019-05-05
End: 2019-07-05

Related international standards
This standard is identical to: EN 10028-6:2017 CEN/TC 459/SC 7

Serbian title

Pljosnati proizvodi od čelika za opremu pod pritiskom - Deo 6: Kaljeni i otpušteni finozrni čelici pogodni za zavarivanje

English title

Flat products made of steels for pressure purposes - Part 6: Weldable fine grain steels, quenched and tempered

Serbian scope

Ovim evropskim standardom se utvrđuju zahtevi za pljosnate proizvode za opremu pod pritiskom od kaljenih i otpuštenih finozrnih čelika, pogodnih za zavarivanje, kao što je utvrđeno u tabeli 1. Zahtevi iz EN 10028-1:2017 se takođe primenjuju.

English scope

This European Standard specifies the requirements for flat products for pressure equipment made of quenched and tempered steels as specified in Table 1. The requirements in FprEN 10028-1:2017 also apply. NOTE Once this European Standard is published in the EU Official Journal (OJEU) under Directive 2014/68/EU, presumption of conformity to the Essential Safety Requirements (ESRs) of Directive 2014/68/EU is limited to technical data of materials in this European Standard (Part 1 and the other relevant part of the series) and does not presume adequacy of the material to a specific item of equipment. Consequently, the assessment of the technical data stated in this material standard against the design requirements of this specific item of equipment to verify that the ESRs of Directive 2014/68/EU are satisfied, needs to be done.

Technical committees


ICS



Directive