Do you use standards in your work?
Don't know
Total votes: 186

dnaSRPS EN 10028-5:2017

Phase: 50.60 - Завршетак поступка одобравања дефинитивног текста нацрта српског стандарда
Start: 2019-05-05
End: 2019-07-05

Related international standards
This standard is identical to: EN 10028-5:2017 CEN/TC 459/SC 7

Serbian title

Pljosnati proizvodi od čelika za opremu pod pritiskom - Deo 5: Termomehanički valjani finozrni čelici pogodni za zavarivanje

English title

Flat products made of steels for pressure purposes - Part 5: Weldable fine grain steels, thermomechanically rolled

Serbian scope

Ovim evropskim standardom se utvrđuju zahtevi za pljosnate proizvode od finoznih čelika za opremu pod pritiskom, dobijenih termomehaničkim valjanjem, pogodnih za zavarivanje, kao što je utvrđeno u tabeli 1. Ovi čelici nisu pogodni za oblikovanje u toplom stanju.

English scope

This European Standard specifies the requirements for flat products for pressure equipment made of thermomechanically rolled steels as specified in Table 1. The steels are not suitable for hot forming. NOTE 1 At the time of publication of this European Standard, no sufficient data for the standardization of the elevated temperature properties of these steels was available. If their use at such temperatures is intended the conditions for this should be specially agreed between the interested parties. The requirements of EN 10028 1:2017 also apply. NOTE 2 Once this European Standard is published in the EU Official Journal (OJEU) under Directive 2014/68/EU, presumption of conformity to the Essential Safety Requirements (ESRs) of Directive 2014/68/EU is limited to technical data of materials in this European Standard (Part 1 and the other relevant part of the series) and does not presume adequacy of the material to a specific item of equipment. Consequently, the assessment of the technical data stated in this material standard against the design requirements of this specific item of equipment to verify that the ESRs of Directive 2014/68/EU are satisfied, needs to be done.

Technical committees